Anchors

I just finished making the Stocks for the Anchors.

Wood Stocks and Anchors pre painting

Parts of an Anchor

Arm-Part of the anchor extending from the crown end of the shank and connecting to the palm.

Band-Metal loop securing the two sections of the wooden stock together and to the shank.

Bill-Very tip end of palm.

Crown-The pointed end of the anchor which attaches the shank to the arms.

Eye-Hole in the end of the shank through which the ring is attached.

Fluke-The spade shaped appendage of the arm used for digging into the sea bed in order to secure the vessel.

Palm-Flat upper most portion of the fluke.

Ring-The working end of the anchor which rope or chain was attached to connect the anchor to the vessel.

Shank-The vertical stem of the anchor.

Stock-Cross bar of the anchor which turns the anchor into an attitude that enables the fluke to dig in to the sea bed.

Throat-The curvature between the shank and the upward part of the arm.

Wire Bands around Stock
Wiring Bands

So these Bands I’m putting around the Anchor Stocks, I say on the pain in the ass scale, it’s probably about a 5 or 6.

The inside ones I wrap so that 2 turns show on top. The outside ones, only 1 turn.

I wrap the wires one at a time then apply Superglue. Wait a bit, then trim the wires.

Outer Bands get 1 wrap

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.